pentair screenlogic app will not connect

These systems don’t bond well unless you connect the protocol adapter directly to a mesh point. If the message bugging your spa moments reads as “Searching for system controller”, and you have a mesh system, here’s a quick fix that might work. When faced with multiple ports (LAN/WAN), connect both to the “LAN” port. If your PC is attached wirelessly, there are high chances that the wired subnet is different from the wireless one, depending upon where the Protocol adapter is plugged.įor a hard-wired Protocol adapter (attached through Ethernet cable) plugged into a router or switch, ensure the device (e.g. Your phone or the PC may be on a different subnet and, therefore, won’t appear. In this case, you may not see any of the Screenlogic protocol adapters when you try connecting locally or remotely. Try uninstalling and then reinstalling the app once too.Ī different subnet can block out both connections. Grab a paper clip and press the reset button three times in the hole of the protocol adapter before waiting 30 seconds for it to work again. Resetting every device (especially the protocol adapters and the wireless router) will help bring Screenlogic back on track for remote and local connection issues. You can also try the previous step again if it doesn’t work once when you try it, though hit the reset button on each device this time around. For a gazillion connection issues, there is this little solution which works in the majority of cases. Screenlogic can be acting up, but sometimes all it needs to work again is a simple reboot. This should reset the system in case of Dynamic addresses.

Once you see the router booted, turn on the rest of the devices attached to the router. Screenlogic wireless router would power up the protocol adapter. Now switch them on again, starting with the modem (cable/DSL), wireless router, the control center and Screenlogic wireless router. Start by turning off the modem, router, control center and all the internet devices connected to the router. Uniforming the network will solve the problem in this case. Many routers can emit more than a single signal. If you are running more than a single wireless router, this probably is why your Screenlogic is writhing with issues. Make sure that the network remains the same throughout. Here’s what to do if your Screenlogic refuses to connect locally or remotely:Ī network issue is the most common reason for a failed connection, impacting both the local and the remote connection. The sooner you find the cause, the quicker you can deal with the problem. But you can manage well if you tweak around in a set pattern. However, occasionally, you can encounter some problems, and troubleshooting may seem daunting, without the help of a professional. You can’t go wrong with this, as managing the pool becomes nearly effortless.

Screenlogic is practical, versatile and offers a reliable interface to monitor your spa.

Pentair screenlogic app will not connect